Archive for Plumbing Guides
Sometimes when you are replacing a valve (see our step by step guide here) the Brass Bush (Ring) that surrounds the valve also comes out with the old Valve. The Bush can come embedded with the valve due to wear and tear/dirt in the water etc and they can seem to be ‘one piece’. You […]
Continue Reading →Posted in: Helpful Tips, Plumbing Guides
Leave a Comment (8) →There is a shroud , locking nut piece 1243R in the image below at the base of your spout. You just need to turn this Anticlockwise to loosen. You can purchase a new Opus O Ring kit here O RING KITS O Rings: If your Tap is leaking at the joint of the body of […]
Continue Reading →Posted in: How to...., Plumbing Guides
Leave a Comment (8) →FAQ How do i prepare for installation of my Tap? First shut off your cold and hot supply and water heating system. Then with your mains stop cock closed, open the lowest hot and cold taps in the house and allow to run until the cold storage tank and pipes are empty (the hot water […]
Continue Reading →Posted in: Helpful Tips, How to...., Plumbing Guides
Leave a Comment (0) →In the product specification of each tap we have listed the water pressure requirement for each tap. Beside this, in the Tab ‘Downloads / Technical Spec’ we have also listed the individual manufacturers guide to the minimum water pressure that is required to ensure the proper working of your Kitchen Tap. Please use these water […]
Continue Reading →Posted in: Helpful Tips, Plumbing Guides
Leave a Comment (0) →To remove spout from mixer Tap: unscrew the “shroud (locking nut)” that sits at the base of the spout and then just pull the spout out. This would apply to all UK Kitchen taps without grub screws where there is a locking nut. If your Kitchen Tap has neither a grub screw or a locking […]
Continue Reading →Posted in: Helpful Tips, Plumbing Guides
Leave a Comment (0) →