Archive for How to….
Its very simple to distinguish between the Hot and the Cold San Marco 1/4 turn valves: The Hot Valve has a nick on every side of the nut whereas the Cold valve doesn’t. More importantly though, Valves open clockwise and anticlockwise. To open a Cold Valve you turn the Splines (at the […]
Continue Reading →Question: Hi, is there any tips on How to remove brass bush from Valve? I have tried wwd40 but seems solid. Answer: The Valve Bush (Brass Ring) is a separate part that surrounds the Valve & is a part used in some (but not every) Tap. Over time grit or debris like Limescale can cause […]
Continue Reading →There is a shroud , locking nut piece 1243R in the image below at the base of your spout. You just need to turn this Anticlockwise to loosen. You can purchase a new Opus O Ring kit here O RING KITS O Rings: If your Tap is leaking at the joint of the body of […]
Continue Reading →Posted in: How to...., Plumbing Guides
Leave a Comment (8) →FAQ How do i prepare for installation of my Tap? First shut off your cold and hot supply and water heating system. Then with your mains stop cock closed, open the lowest hot and cold taps in the house and allow to run until the cold storage tank and pipes are empty (the hot water […]
Continue Reading →Posted in: Helpful Tips, How to...., Plumbing Guides
Leave a Comment (0) →Some suggestions for Kitchen Taps to go with square sinks that would echo the square shape of the kitchen sink. Using the Deca Undermount sink as an example of a modern square sink. The Deca is a square sink in shape and can be undermount or inset (it’s actually the square sink that I chose for my […]
Continue Reading →Posted in: Helpful Tips, Kitchen Design
Leave a Comment (0) →